Tel: +86-13962947398
Home > News > Content

Debugging Skill Of Pattern Conveyor Belt

Yutung Industrial Limited | Updated: Jul 25, 2017

             The running deviation of conveyer belt is the most common fault of belt conveyor, and its timely and accurate treatment is the guarantee of its safe and stable operation. There are many phenomena and reasons of running deviation, so we should adopt different adjustment methods according to different deviation phenomena and reasons to solve the problem effectively. This paper is based on many years of field practice, from the user's point of view, the use of mechanical principles to analyze and explain the causes of such failures and treatment methods.Pattern Conveyor Belt

             The head drive drum or the tail of the drum and the axis of the conveyor center line is not vertical, resulting in the conveyor belt in the head drum or the tail of the drum to run on the side. When the rollers are deflected, the tightness of the conveying belt on both sides of the drum is inconsistent, along the direction of the width of the traction FQ also is inconsistent, to increase or decrease the trend, so that the conveyor belt is added to the direction of the moving force FY, resulting in the conveyor belt to the loose side run, that is, the so-called "run loose not run tight." The adjustment method is: for the head drum such as conveyor belt to the right side of the drum, then the right side of the bearing seat should be moved forward, the conveyor belt to the left side of the drum, then the left side of the bearing seat should be moved forward, the opposite side of the bearing seat can be shifted back or the right side of the The adjustment method of the tail roller is just the opposite of the head cylinder. After repeated adjustment until the conveyor belt is tuned to an ideal position. It is best to install the position accurately before adjusting the drive or the drum.Pattern Conveyor Belt

             The external surface of the drum machining error, viscosity or wear caused by uneven diameter, conveyor belt will be larger diameter side run deviation. So-called "run Big not run small". The traction FQ of the conveyor belt produces a moving force FY to a large diameter side, and the conveyor belt generates an offset under the action of the partial force FY. For this situation, the solution is to clean up the surface of the drum, processing errors and wear uneven will be replaced to process the processing of plastic.Pattern Conveyor Belt