Tel: +86-13962947398
Home > News > Content

Some Common Problems In The Use Of The Pattern Conveyor Belt

Yutung Industrial Limited | Updated: May 31, 2017

The strength of the Pattern Conveyor Belt is lower than that of the normal belt. General mechanical form of the joint, the joint strength can only reach the body strength of 40-50%, cold glue in the form of better quality, the joint strength can reach 60-70%, while the thermal adhesive strength can reach 80-90% (Joint method is accurate, no lack of quality). Because the joint part of the strength is relatively low, if the bonding method is wrong, the joint strength will be more low, such as surgery, grinding and then hurt the next layer of cloth, polished over, lap length is not enough, the number of steps is not enough, Rubber performance is very bad or has been ineffective from the sulfur, wire rope polished, rusty rope, etc., the joint part of the strength will be discounted, in use, it is easy to reveal the phenomenon of joint parts fracture.

    In addition to this, the Pattern Conveyor Belt belt is not considered suitable if the use of sealing adhesive, or glue the direction of the joint is not correct, the joint site is easy to reveal the emergence of cracks (glue area).

 When the Pattern Conveyor Belt is in normal operation, the belt speed is not lower than 95% of the roll speed. If the roller and the Pattern Conveyor Belt belt friction is not enough, the Pattern Conveyor Belt belt is easy to reveal the phenomenon of slip out. Driving roller and Pattern Conveyor Belt belt is not enough of the end of the friction by the many, the common are: the tension is not enough, the load began to work, the roller surface friction coefficient is not enough. Rally is not enough of the end by: tension is not enough, with the amount of blocks is not enough, the Pattern Conveyor Belt belt is too long;

The outer surface of the roller friction coefficient is not enough by the: roller powder and water fermentation made of food glue wear too much, the body is too wet or sticky with lubricating oil, with the body surface sticky material (easy to water up ).

Film, mortar should be kept in a gloomy, dry place, to prevent direct mapping of sunlight, to prevent a variety of radiation, and away from fire.

    Film, mortar should be kept in a large place to prevent dust, to prevent a variety of chemical things with their contact.

    Keep the film, glue the background of the degree of wetness 50 percent 100 percent -75 percent, the temperature should not be less than 5 ℃, not more than 35 ℃.

    Film, mortar retention period: summer 1 month, winter 2 months, spring and autumn and a half months.